Introduction

What it is and what it is not

Homey Easy Charge Controller is a Homey App than can control an another Homey App, based on Nordpool prices, your prefererences and input from other Homey Apps. It is intended to be wired with Homey Flows or Advanced Flows to get information from other sources and to control other Homey Apps and Devices.

When a Controller device is created you should initialize it with some setup. 

Suggested steps to start with

1. Install the app from App Store
2. Then add new Device, select Easy Charge Controller and the Controller device
3. Select Connect
4. You should get one Charge Controller device
5. Add it
6. You should see it like this 
   Image Added
   
   
7. the selections in the bottom
   Image Added
8. From left to rigth this is what you can do
   1. turn on/off the controller
   2. slider ot set current State of Charge (SoC) and target SoC
   3. you can set the amount of hours you want to charge and the ned time where the charing is supposed to be finished
   4. In section nr 4 from left alle values in the controller is displayed.
   5. Last is flows and state infomation

Heres some examples to visualize typical flows you may want to create.

To connect commands from the controller to the charger

To feed charger status into the Easy Charging Controller